3-Pack Nano V3.0 ATmega328P USB-C + PinPulse LED Shield

• 3 x NANO V3.0 BOARDS ATmega328P AT 16MHZ: 32KB Flash, 2KB SRAM, 1KB EEPROM, 14 digital I/O with 6 PWM, and 8 analog inputs. Reversible USB Type-C connector, so no more flipping the plug and no special cable to keep track of.
• SEE EVERY I/O PIN STATUS LED ON EACH ONE: TX/RX, D2-D13 and A0-A7 all get an indicator on the PinPulse Shield. Check HIGH or LOW at a glance instead of reaching for a multimeter or filling the serial monitor with print statements.
• BUFFERED, NON-INTRUSIVE SN74HC04D HEX INVERTERS: the LEDs are driven through buffers rather than tapped straight off the pin, keeping the load off your signals so I2C, SPI and UART timing stays clean.
• MALE AND FEMALE ON EVERY PIN DUAL-GENDER 2.54MM HEADERS: male-to-male, male-to-female and female-to-female jumper wires all plug straight in. No adapters, no hunting through the box for the right cable.
• READY TO RUN 5 PIECES IN THE BOX: 3 x Nano V3.0 boards, 1 x PinPulse Shield, 1 x USB Type-C cable, plus a printed quick-start card covering the CH340 driver and Arduino IDE setup. Sensor and display modules shown in the images are not included.
• 100% Arduino IDE Compatible Works seamlessly with existing sketches, libraries, and shields.
• Perfect for Education & Hobby Visual LEDs + flexible pins reduce errors and speed up learning/experimentation.

Specifications